Design of five-leg inverter control for driving two three phase induction motors using a direct torque control technique
This paper presents the design of five-leg inverter control driving two three phase induction motors
using a direct torque control technique (DTC). It allows a reduction in leg counts compared with a classical
the DTC for three-leg inverters. The simulation model of the system is created and analyzed by using the
Matlab/Simulink program. The obtained results confirm that both motors are able to operate at different speed and different load conditions.
Copyright (c) 2014 KKU ENGINEERING JOURNAL
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
|KKU Engineering Journal, 7th Floor, Pienvichitr Building,|
|Faculty of Engineering, Khon Kean University,|
|Muang, Khon Kean, 40002 Thailand|
|Tel: +66(0) 4336 2145-6 ext. 603 Fax: +66(0) 4336 2142|