KKU ENGINEERING JOURNAL

KKU ENGINEERING JOURNAL was published by the Faculty of Engineering, Khon Kaen University (KKU),  the journal was committed to provide academic and research works in Engineering and Technology.

This journal uses double blind peer review.


Journal Homepage Image

Indexed in tci


Vol 41, No 3 (2014)

Table of Contents

ORIGINAL ARTICLES

Physic-chemical characterization of “Namu” clay for industrial use pdf
Olatunde Ajani Oyelaran 283-290
Defect reduction for fabric cutting process to produce polo shirts : a case study of garment factory pdf
Panicha Suttanako, Porntep Khokhajaikiat 291-299
Equipment to detect bad isolator in hard disk drive testing process pdf
Winai Tumthong, Prasertsiri Varunchittapongsa, Jiraphon Srisertpol 301-311
Effectiveness of Motorcycle speed controlled by speed hump pdf
Pornsiri Urapa, Jindaporn Jamradloedluk, Sahalap Homvutivong, Wichuda Satiennam 313-320
A simulation-based inventory management with genetic algorithm for uncertain demand for third-party logistics provider pdf
Wuthichai Wongthatsanekorn, Jiraporn Saelim 321-332
Vehicle kilometers of travel and fuel consumption rate for estimating CO2 emission of vehicles in Khon Kaen city pdf
Thaned Satiennam, Wichuda Satiennam, Somphod Gadsadayurat, Supakorn Aranyasen, Kittiphope Srisa-ard 333-346
Reduction of adhesive stain defect in flexible printed circuit board on hot pressing process: a case study of electronic component factory pdf
Sakulkaew Srisang, Somchai Puajindanetr 347-355
Crashworthiness behavior of fiberglass tube subjected to axial load pdf
Visit Junchuan, Chawalit Thinvongpituk, Somya Poonaya, Ratchada Sopakayang 357-366
Double input converters for different voltage sources with isolated charger pdf
Chalash Sattayarak, Pituk Bunnoon 367-372
Volatile organic compounds adsorption using different types of adsorbent pdf
Pimanmes Chanayotha, Somjai Kajorncheappunngam 373-381
The efficiency of different types of wood charcoal on increasing carbon content on surfaces of low carbon steel in the pack carburizing process pdf
Narongsak Thammachot, Wanna Homjabok, Naruedom Thadee 381-391
Improvement of Thai error correction system by memetic algorithm pdf
Krit Somkantha, Wilaiporn Kultangwattana 393-402
Phase morphological study on SEBS compatibilized PS/LDPE blends pdf
Chatchai Kunyawut, Julia S. Higgins 403-413
Effects of HCl and HNO3 on the oxidation of toluene to benzaldehyde by H2O2 over TS-1 modified with Al in aqueous phase pdf
Paricha Pongjirawat, Sunantha Kaenthong, Tharathon Mongkhonsi 415-420