The Comparison of Energizer between the Rubber Wood Ash and CaCO3in the Pack Carburizing Process with Rubber Wood Charcoal Powder

Main Article Content

พีรวัส คงสง
นันทนา จันทร์โสม
ศิริพร เฝ้าหนองดู่

Abstract

The purpose of this research is to apply a pack carburizing process for low carbon steel hardening with rubber wood charcoal to improve the mechanical properties of low carbon steel grade AISI 1020. The depth hardness of low carbon steels hardening was compared with those of non-hardened low carbon steel. The experiment was made by pack carburized low carbon steel at 950°C with the carburizing time of 30, 60 and 90 min and cooled in air. It was heated by austenitizing treatment at the temperature of 850°C for 30 min and quenched in water. The specimens were tempered at a temperature of 150°C for 30 minutes. The carburizing substance is rubber charcoal mixed with 10% of energizer such as rubber wood ash and CaCO3. The specimens were checked for case depth by Micro-Vicker testing and microstructure inspection. The results showed that the rubber wood charcoal mixed with CaCO3 energizer at 950°C with the carburizing time of 90 min produced the highest hardness value of 681 HMV and the surface hardness of rubber wood ash was 665 HMV. It was also found that the microstructure on the surface with both CaCO3 and rubber wood ash were martensite and cementite. For this reason, rubber wood charcoal ash can be used as an energizer to pack carburizing as well.

Article Details

How to Cite
คงสง พ., จันทร์โสม น., & เฝ้าหนองดู่ ศ. (2019). The Comparison of Energizer between the Rubber Wood Ash and CaCO3in the Pack Carburizing Process with Rubber Wood Charcoal Powder. Rajamangala University of Technology Srivijaya Research Journal, 11(2), 208–218. Retrieved from https://li01.tci-thaijo.org/index.php/rmutsvrj/article/view/198055
Section
Research Article
Author Biographies

พีรวัส คงสง, Faculty of Engineering and Architecture, Rajamangala University of Technology Isan

Department of Materials Engineering, Faculty of Engineering and Architecture, Rajamangala University of Technology Isan, Nakhon Ratchasima 30000, Thailand.

นันทนา จันทร์โสม, Faculty of Engineering and Architecture, Rajamangala University of Technology Isan

Department of Materials Engineering, Faculty of Engineering and Architecture, Rajamangala University of Technology Isan, Nakhon Ratchasima 30000, Thailand.

ศิริพร เฝ้าหนองดู่, Faculty of Engineering and Architecture, Rajamangala University of Technology Isan

Department of Materials Engineering, Faculty of Engineering and Architecture, Rajamangala University of Technology Isan, Nakhon Ratchasima 30000, Thailand